PROCEDURE:

1. BOLT ON STEERING ASSEMBLY SO IT APPEARS AS SHOWN INCLUDING THE REVERSE CABLE BRACKET.

2. MAKE CHANGES TO SHIFTER AS SHOWN ABOVE.

3. PLACE SHIFTER IN REVERSE.

4. RUN REVERSE CABLE THRU CABLE BRACKET.

5. SCREW ON ROD END, FASTEN TO REVERSE BUCKET WITH CLEVIS THEN USE COTTER PIN TO RETAIN.

6. PLACE SHIFTER IN REVERSE.  ADJUST JAMB NUTS ON CABLE CONDUIT SO THAT BUCKET IS TIGHT AGAINST THE BUCKET STOP.

7. CONNECT STEERING EXTENSION AND CENTER STEERING WHEEL BY ROTATING THE WHITE PLASTIC BALL ON THE STEERING TUBE (LOOSEN BALL BEZEL FOUR SCREWS).