|
JET DRIVE INSTALLATION MODEL SD-312 |
| These instructions apply to transom angle
of 8 degrees and from 1/8” to 3/8” thick and dead rise angles from 0 to 20
degrees. INTAKE CUTOUT The intake cutout dimensions are shown on EXHIBIT J or EXHIBIT K. EXHIBIT J is for a Vee Bottom boat and EXHIBIT K is for a Delta Bottom boat. TRANSOM CUTOUT An initial cut-out is made in the transom to allow the intake to be installed. See EXHIBIT J or EXHIBIT K. INSTALLING INTAKE a. Weld both sides of the intake inside and out. b. Mark and drill transom mounting holes. c. Mark and drill cutout holes. d. Complete transom cutout for standard steering. See EXHIBIT L. e. Complete transom cutout for HTR II steering. See EXHIBIT M. f. See sealant placement detail before installing jet unit. See EXHIBIT N. |